Driver Sitting
$135about 100 minutes
Strike census, keep rate analysis, head and shaft work, length and swingweight resolved together. Includes the spec card and your season file.
You Are Paying For The Hour, Not The Answer
Every figure on this page is what it costs to have the studio's time and instruments pointed at your golf. None of it is refunded, discounted, or credited against a purchase, because the moment a fitting fee depends on an order the fitting stops being independent.
Fitting On The Floor
Iron Sitting
$185about 130 minutes
The full set. Bench measurement of every existing iron, lie board work on turf, sole and ground answer testing, progression audit, gapping in carry, and shaft profiling across the set.
- Covers up to nine clubs including pitching wedge
- Includes bending your existing set to the new spec if you keep the heads
Wedge Sitting
$120about 90 minutes
Grind and effective bounce on soft and firm panels back to back, bunker work, and honest carry gapping from your shortest full iron down.
Fairway Wood Or Hybrid Sitting
$11075 to 90 minutes
Booked separately or together. Includes the long-iron crossover analysis that decides how many of each you should be carrying in the first place.
Putter Sitting
$105about 75 minutes
Length and eye position, dynamic loft at impact, stroke arc tracing, and head balance matched to it. Rolled on a surface set to your home green speed.
Full Bag Sitting
$395two visits, about 4 hours total
Everything above, split across two appointments a week apart so nobody is making decisions at hour four. Worth it if you are genuinely rebuilding; unnecessary for most people, and we will say so.
Work That Does Not Need The Floor
| Job | Rate | Notes |
|---|---|---|
| Loft and lie check, per club | $6 | Free on any set we built |
| Loft and lie adjustment, per club | $9 | Cast heads assessed before bending |
| Regrip, per club | $7 plus grip | Build-up wraps included |
| Reshaft, per club | $28 plus shaft | Includes spine orientation and tip work |
| Shaft pull and reuse | $18 | Only where the ferrule and tip survive |
| Swingweight match, per set | $45 | Tip weighting and grip adjustment |
| Gapping review | $60 | 45 minutes, no head changes |
| Shaft profiling, per shaft | $8 | Free during any sitting |
| Season file check | No charge | March and September, past clients |
How A Build Is Priced
Two lines, always shown separately. Components at our cost, and a flat assembly fee per club. There is no third line and no margin hidden inside the component figure.
- Wood or hybrid assembly, per club$32
- Iron assembly, per club$26
- Wedge assembly, per club$26
- Putter assembly, including length and loft set$40
- Set matching and final frequency plot$45 per set
Component cost appears on the invoice at what we paid, and we will show you the supplier line if you want to see it. A typical full iron rebuild — new shafts and grips into heads you already own — runs between four and seven hundred dollars all in, which is generally a third of what the same golfer was expecting to spend on a new set.
Deposit is fifty percent at order, balance on collection. Special-order components are non-returnable once cut, which we will remind you of at the point it matters.
The Things Worth Knowing In Advance
Cancellations
Twenty-four hours notice and there is no charge. Inside that we ask for half, because the slot cannot be refilled at short notice when the floor takes one golfer at a time.
Juniors
Under sixteen, half rate on any sitting. Growing golfers need checking every season and we would rather that not be a financial decision.
Second Visits
If we order a component in for you to test properly, the retest visit is free. It is part of the original sitting, not a new one.
Payment
Cash or card, taken at the end of the sitting. We do not take deposits to hold a fitting slot and we do not sell gift certificates against future purchases.